Congratulations on your new neon sign from Neonful

We hope you will be happy with your new LED neon sign from Neonful. Here's a checklist you can use for unpacking and installing the sign:

Check that everything is included in the package.

The package from us always includes:

  • the sign itself
  • a mounting kit with screws and wires
  • a power supply in the form of an adapter and power plug.

In addition, a dimmer box/remote control may be included if this is part of the purchase.

Check that the sign is perfect

Always check that the sign is complete and undamaged. We have been subjected to rough treatment during transport, but fortunately this happens very rarely.

Remove the protective film from the sign (IMPORTANT)

If the sign is supplied with a protective film on the back, for example in the form of a thin paper-like film, it must be removed before the sign is switched on. The easiest way is to wait until the sign is at room temperature, as the backing paper is then ready to peel off.

This is important so that the sign can get rid of the heat it gives off when it is lit.

Neon sign with brown protective film on the back

 

Hanging of the neon sign

Both mounting screws and wires are always included with Neonful neon signs. If the sign is screwed in place, it is important that there is clearance to the wall, and this is most safely achieved by using the supplied spacer screws from the mounting kit. Do not screw the sign all the way to the wall, as this can cause problems with heat build-up. This is not dangerous in itself, the sign is only 12V, but the wires can overheat and break anyway.

Mounting kit for LED neon signs

 

Interconnection

With the sign comes one / more adapters and as mentioned dimming box. It is important that all parts are used/connected. If this is not done, the sign may shine too dimly, and there is a risk that the wiring may break. The long male connectors from the sign must be connected to the male connector of the dimmer box (marked with either Output or LED). The female connector of the dimmer box is connected to the adapter.

Dimmer box and remote control for LED neon sign

 Remember to put batteries in the remote control.

Need help?

Remember, if you have any doubts or the sign doesn't live up to your expectations, we're here to help. Both at hey@neonful.dk or at 71789555 during our service hours.